Hello everyone,
I have a DH-IPC-HDBW2841R-ZS Dahua camera and I need to set a zoom on it via API to a specific value.
When I send this API /cgi-bin/configManager.cgi?action=setConfig&VideoInZoom[0][0].DigitalZoom=true&VideoInZoom[0][0].Speed=5&VideoInZoom[0][0].ZoomLimit=10 I get the response OK and later when I check I see that those values are in fact set.
However, when I enter to see the view of the camera, I see that everything is the same as it was previously, meaning no zooming has actually been done.
I checked and it seems that this camera does not have PTZ so I cannot use that to set my zoom.
Any suggestions of how to fix my issue?
Thank you!
I have a DH-IPC-HDBW2841R-ZS Dahua camera and I need to set a zoom on it via API to a specific value.
When I send this API /cgi-bin/configManager.cgi?action=setConfig&VideoInZoom[0][0].DigitalZoom=true&VideoInZoom[0][0].Speed=5&VideoInZoom[0][0].ZoomLimit=10 I get the response OK and later when I check I see that those values are in fact set.
However, when I enter to see the view of the camera, I see that everything is the same as it was previously, meaning no zooming has actually been done.
I checked and it seems that this camera does not have PTZ so I cannot use that to set my zoom.
Any suggestions of how to fix my issue?
Thank you!