Hello.
I'm in the process of replacing my old Hikvision ip cameras with new 2146's, OEM, 2.8 mm, latest firmware V5.5.801 build 211105.
I've set up the motion detection, and it basically works. It records to a SD-card in the camera, and triggers recording on my synology nas.
But the motion detection in the cameras is not sensitive enough.
If I'm walking towards the cameras, recording is not started before I'm less than 4-10 meters away.
I've tried both expert mode and normal.
Drawn ares that covers most of the image frame, and smaller areas as well.
Sensitivity is set to maximum = 100.
In the cameras online help it says
“Slide the cursor to adjust the sensitivity and proportion of object on the area for the selected area.”
The “Proportion of object” slider is missing – think it was named “Percentage” in the old cameras (2132).
I've enabled the "Dynamic analysis for motion detection".
The camera sees the motion further away than the 10 meters - covering the image with green squares where the motion is, but the recording is not started.
The event is not triggered, its not registered in the log (system, maintenance, logs).
Small birds and leaves near the camera starts recording.
So, the camera sees the motion, but why is the event not fired?
Have i missed something?
-
I'm in the process of replacing my old Hikvision ip cameras with new 2146's, OEM, 2.8 mm, latest firmware V5.5.801 build 211105.
I've set up the motion detection, and it basically works. It records to a SD-card in the camera, and triggers recording on my synology nas.
But the motion detection in the cameras is not sensitive enough.
If I'm walking towards the cameras, recording is not started before I'm less than 4-10 meters away.
I've tried both expert mode and normal.
Drawn ares that covers most of the image frame, and smaller areas as well.
Sensitivity is set to maximum = 100.
In the cameras online help it says
“Slide the cursor to adjust the sensitivity and proportion of object on the area for the selected area.”
The “Proportion of object” slider is missing – think it was named “Percentage” in the old cameras (2132).
I've enabled the "Dynamic analysis for motion detection".
The camera sees the motion further away than the 10 meters - covering the image with green squares where the motion is, but the recording is not started.
The event is not triggered, its not registered in the log (system, maintenance, logs).
Small birds and leaves near the camera starts recording.
So, the camera sees the motion, but why is the event not fired?
Have i missed something?
-