help confirming Blue iris camera settings for alpr

[trapper]

Set up BI/Code project installed modules all good. System was getting approx 65 percent of all day plates and they would show new and alerts. I did some tweeks (big mistake) and now all alpr alerts show alert cancelled nothing found. I have attached all the camera settings. Can someone help me with correcting the mistakes I made. Now vehicle triggers alert, shows in events and than disappears. the event shows a partial vehicle and the plate has not entered the frame. the last picture shows a vehicle /focus of the plate. As always thanks for any help

 

[Flintstone61]

My version Of BI is dated compared to what your menu's show. So i am not Apples to Apples. I don't have some of the switches available that your menu's show.
Here are my basic motion sensor settings.

 

[Flintstone61]

 

[Flintstone61]

 

[trapper]

flintstone thanks for the help. those setting got me in the right direction. My last challenge is when the bi alerts to motion it starts a recording , can see it on the time line and than a few seconds later the red lighting bolt turns to a white circle with a slash. Bi status log shows alert triggered motion and ai cancelled nothing found. any help on this on thanks again

 

[looney2ns]

Have you tried rebooting the machine?

 

[trapper]

yes did a restart. question is there a way to bring all BI setting back to the original state. Back to default settings button.

 

[trapper]

deleting the camera and adding it back should do it