I'm connecting a PIR motion sensor to new PTZ and am wondering how to best connect the relay wires to the small wires on the pigtail.
Twist the wires and then electrical tape down the wire insulation a few inches? I've done this in the past, but it creates an upside-down V shape that isn't very tidy
For audio in, I'm going to use an RCA balun so I feel better for that one: Amazon.com: AILTECK RCA Cable Audio Adapter, Phono Speaker Wire to Male RCA Connector Adapter Plug, AV Screw Terminal solderless Adapter(2-Pack): Industrial & Scientific
What do you folks do for these very thin pigtail wires so they don't break?
Twist the wires and then electrical tape down the wire insulation a few inches? I've done this in the past, but it creates an upside-down V shape that isn't very tidy
For audio in, I'm going to use an RCA balun so I feel better for that one: Amazon.com: AILTECK RCA Cable Audio Adapter, Phono Speaker Wire to Male RCA Connector Adapter Plug, AV Screw Terminal solderless Adapter(2-Pack): Industrial & Scientific
What do you folks do for these very thin pigtail wires so they don't break?
As an Amazon Associate IPCamTalk earns from qualifying purchases.