Justincase13
n3wb
Hello,
I recently picked up a EG4-DL20ME-32G camera from Amazon.
They have disabled SSH/Telnet on this device and I'm hoping to get access via serial so I can upload my own firmware/kernel or simply enable these services.
Does anyone happen to have a clue as to where TX/RX would be on this board?
Some other guys found TX/RX at some resisters on a similar Hi3518 board..but it's not clear on this one.
I found the UART serial pins but that's only for PTZ function and it's running 9600 baud.
Also the 3 pads at the bottom right are for IR and not TTL.
Any help is greatly appreciated.
Thanks,
-Justin
I recently picked up a EG4-DL20ME-32G camera from Amazon.
They have disabled SSH/Telnet on this device and I'm hoping to get access via serial so I can upload my own firmware/kernel or simply enable these services.
Does anyone happen to have a clue as to where TX/RX would be on this board?
Some other guys found TX/RX at some resisters on a similar Hi3518 board..but it's not clear on this one.
I found the UART serial pins but that's only for PTZ function and it's running 9600 baud.
Also the 3 pads at the bottom right are for IR and not TTL.
Any help is greatly appreciated.
Thanks,
-Justin
Attachments
-
225.9 KB Views: 16
-
316.9 KB Views: 11
-
795.3 KB Views: 21
-
795.3 KB Views: 13