hikvision DS7608NI-E2/8P/A POE NVR PROBLEM

[wat180]

HI
I need help please I am trying toaccess my cameras individualy
To make fine adjustments but sinceconnecting them to the
Hikvision DS7608NI-E2/8P/A BUILDV3.4.0
I can’t do this looking at someother threads on the matter I have
Connected the LAN cable from myrouter into a spare POE PORT
and looped a Ethernet cable from another sparePOE PORT to
The LAN input of the NVR now I cansee all the camera IP addresses
on my remote computer but I still cannot access them on my web browser
The NVR doesn’t seem to have thevirtual host option
MANY THANKS in advance for anyadvise
Paul

 

[alastairstevenson]

now I cansee all the camera IP addresses
on my remote computer

Using SADP presumably?
SADP will see the cameras even when they are on a different IP address range from the PC.
I'm guessing they will be something like 192.168.254.x
If so - set your PC IP address to, say, 192.168.254.100 and then the browser access should work OK.
And by the way - normally you'd just temporarily connect your PC directly to a spare PoE port and the NVR LAN interface would normally be on your router anyway.
On Virtual Host - did you look for the 'enable' checkbox in the NVR web GUI under Advanced Networking configuration?

 

[wat180]

Using SADP presumably?
SADP will see the cameras even when they are on a different IP address range from the PC.
I'm guessing they will be something like 192.168.254.x
If so - set your PC IP address to, say, 192.168.254.100 and then the browser access should work OK.
And by the way - normally you'd just temporarily connect your PC directly to a spare PoE port and the NVR LAN interface would normally be on your router anyway.
On Virtual Host - did you look for the 'enable' checkbox in the NVR web GUI under Advanced Networking configuration?

Hi
cannot see the virtual host check box

 

[alastairstevenson]

cannot see the virtual host check box

It does seem a bit of a mystery which models and which firmware provides it - and where to find it.
This is on a 7816N-E2 with 3.3.4 firmware, probably different from many others.