HIKVISION mtd Brick Recovery Guide

[Allseeingeye]

I just found this thread today trying to fix a new Annke camera that failed a firmware upgrade. The camera never connected to 192.0.0.128 on TFTP but a packet capture on the network showed some life from the camera on IP 192.168.1.83 looking for 192.168.1.128 so i changed the IP of the PC to 192.168.1.128 and the camera connected to the TFTP-server. Not home free yet, but maybe this info could help someone else, the camera seems to have been manufactured in April 2021 judging by the serial number, maybe the default IP addressing has changed in newer equipment. It would make sense to change it, as 192.0.0.x is in the public ip space.

 

[tuan_vip]

Hi you
I have 1 bricked IP camera that cannot be found using SADP. How can I re-flash it. The situation happened when I was flashing it and the power went out, after the power came back I couldn't find its ip address

 

[alastairstevenson]

To give you a helpful response, we need more detail, such as the model of camera, the firmware version you were installing.

 

[tuan_vip]

Hi you
My camera ds-2cd2327g3e-l, fw 5.5.94

 

[StanleyM]

I just found this thread today trying to fix a new Annke camera that failed a firmware upgrade. The camera never connected to 192.0.0.128 on TFTP but a packet capture on the network showed some life from the camera on IP 192.168.1.83 looking for 192.168.1.128 so i changed the IP of the PC to 192.168.1.128 and the camera connected to the TFTP-server. Not home free yet, but maybe this info could help someone else, the camera seems to have been manufactured in April 2021 judging by the serial number, maybe the default IP addressing has changed in newer equipment. It would make sense to change it, as 192.0.0.x is in the public ip space.

Hello
I have the same case, my camera is Annke C800 , i had trying to send new firmware and exactly IP server have to be 192.168.1.128 and client appeared IP 192.168.1.69 but i still can't finish upgrade. Camera connecting and tftp shown sending, but never done.

 

[Mikey007]

Hello
I have the same case, my camera is Annke C800 , i had trying to send new firmware and exactly IP server have to be 192.168.1.128 and client appeared IP 192.168.1.69 but i still can't finish upgrade. Camera connecting and tftp shown sending, but never done.

Apparently the the hikvision tftp tool only supports 32mb most of new firmware is greater than that.
There is a guy on gethub called Scott lamb and he made another tool. I have been try to work how to use it no luck yet