Hi Everyone,
Can anyone help me with an issue I have.
I have an Escam wnk804 8ch camera and nvr setup. I wanted to add extra cameras and the NVR was only 8ch so I bought a
Hiseeu H.265 16CH NVR. My extra cameras are a Digoo and a V380. I have decided to wire them all with Network cables instead of wifi.
SO the list is:
Hiseeu H.265 16CH CCTV NVR - DHCP obtained IP address.
8x Escam wnk cameras N1 protocol on network cables Static IP address 192.168.10-17.
1x Digoo W01F Onvif - Network cable DHCP obtained
1x V380 smart cam Onvif - Network cable DHCP obtained
The new Hiseeu H.265 16CH CCTV NVR sees the Digoo and V380 due to them being Ovif compatable but the 8 WNK cameras aren't discoverable.
My PC on the same network sees all of the cameras and displays the pictures fine.
The Hiseeu NVR doesn't seem to even see they are there.
When I look at the camera setup on the old NVR without the new one plugged in, I see the protocol is N1.
The Hiseeu doesn't seem to have this option.
Am I missing something here or are these devices not compatable with each other?
I understand all about Networking so this isn't an ip address conflict or anything like that. WIFI is turned off on all the cameras and the 8 Escams have static ips where the other 2 have DHCP obtained IP'S from my router.
Cheers peoples
Can anyone help me with an issue I have.
I have an Escam wnk804 8ch camera and nvr setup. I wanted to add extra cameras and the NVR was only 8ch so I bought a
Hiseeu H.265 16CH NVR. My extra cameras are a Digoo and a V380. I have decided to wire them all with Network cables instead of wifi.
SO the list is:
Hiseeu H.265 16CH CCTV NVR - DHCP obtained IP address.
8x Escam wnk cameras N1 protocol on network cables Static IP address 192.168.10-17.
1x Digoo W01F Onvif - Network cable DHCP obtained
1x V380 smart cam Onvif - Network cable DHCP obtained
The new Hiseeu H.265 16CH CCTV NVR sees the Digoo and V380 due to them being Ovif compatable but the 8 WNK cameras aren't discoverable.
My PC on the same network sees all of the cameras and displays the pictures fine.
The Hiseeu NVR doesn't seem to even see they are there.
When I look at the camera setup on the old NVR without the new one plugged in, I see the protocol is N1.
The Hiseeu doesn't seem to have this option.
Am I missing something here or are these devices not compatable with each other?
I understand all about Networking so this isn't an ip address conflict or anything like that. WIFI is turned off on all the cameras and the 8 Escams have static ips where the other 2 have DHCP obtained IP'S from my router.
Cheers peoples