How to get a Chinese version of 2.5.2

[vpnmand]

Hi

I have upgraded my DS-2CD3132F-IWS camera with incorrect firmware.

I can log in to the camera via telnet on ip address 192.0.0.64. So little life is in it.

Are there anyone who know how to get a Chinese version of 2.5.2 software ? That was the version I think was on the camera before I updated it? Or are there anyone who have an idea of how to make the camera work again?

 

[alastairstevenson]

Or are there anyone who have an idea of how to make the camera work again?

Check this out for the ways to unbrick and fully update the camera : Hikvision DS-2CD2x32-I (R0) brick-fix tool / full upgrade method / fixup roundup.
Does SADP show the firmware version of 4.0.8 ?
If so, the camera is running in 'min-system' recovery mode due to incompatible firmware.

I have upgraded my DS-2CD3132F-IWS camera with incorrect firmware.

Was this firmware 5.4.0 or higher?
If so, you will need to use the 'brick-fix tool' to allow downgrading.
Then you will need to use the '5.3.0 to 5.2.5 downgrader'.
Then you can consider doing the 'enhance mtd hack' to allow full updating.

 

[vpnmand]

thanks it works now

 

[alastairstevenson]

Well done.
Did you do the full upgrade?

 

[vpnmand]

no only to version 2.5.2