How to wire 59430UNI and 2 pirs

[Ihbond]

Red alarm 1 in
Brown alarm in 2 in
Yellow\green alarm ground

23w with IR \ 13 w no ir
Bosch PIR 10 VDC to 15 VDC at 22 mA standby.
V7 Poe 30w

So I am new and trying to figure this out ahead of time..

So , have not metered above wires yet..but I am assuming that
I can take a parallel 2 wires (red and brown) to each PIR. Then take the groind from the pir’s and run them back to the cameras yellow\green. ...

Do I need to run 2 Poe splinters to get power to the PIR?

Looking for schematics or how to...

Thanks

Is this correct?
Thanks

 

[Ihbond]

well, so much for thinking I their would be DC power froom those camera wires. Sounds like either I need to
1) Run a POE splitter (20 feet) off camera via rj45 and then out to 2 pir's. Then the Pir's no\nc back to camera
2) Run long cable poe (50 feet) (rj45) wire to the 2 pirs and then the PIR no\nc back to the camera
3) buy a sealevel 120e to pir, then back to BLue iris

Thoughts ?

is there better performance running the PIR's back to the camera, or does BI do a decent enough job with the dio's ? Purpose is to trigger and re-direct PTZ camera outside of default lens view.

 

[Go3Team]

Your best bet would be to run a power only (red/black) wire to the camera and PIR. The consumption would probably be too much even for a high capacity splitter.

 

[tangent]

Most PoE Splitters are only 802.3af this camera uses too much for that and uses 803.2at (aka PoE+).
I wouldn't bother trying a splitter.

Options:
-Run a separate cable to the motion detectors for power, power with a 12v supply indoors. Connect no/nc to camera or input device as you choose.
-Power the camera using 24VAC, get a small 24vac to 12vdc adapter that you can put inside of a junction box or similar enclosure. Requires you run a cable to the ptz for 24vac and have a spot to put the 12v adapter.

 

[Ihbond]

Thanks..think I will run another cable to the Poe like suggested and run no\nc to the device...

Appreciate the help...

Just got done running the wires for all my cameras, now just need to create 8p8c ends

 

[tangent]

Thanks..think I will run another cable to the Poe like suggested and run no\nc to the device...

Appreciate the help...

Just got done running the wires for all my cameras, now just need to create 8p8c ends

Make sure you follow the T568B standard.

 

[Ihbond]

Sure did...thanks for the reminder