Impossible to add Ringbell DS-KV6113-WPE1(C) in NVR DS-7608NXI-I2 (HIKVISION protocol)

[Anakins]

Hello,

I added my ringbell DS-KV6113-WPE1(C) in my old NVR DS-7608NXI-K1 (firmware v4) with no issue. I can access camera and make trigger with motion detection.
I bought a DS-7608NXI-I2 (firmware v5) but impossible to add the ringbell with HIKVSION protocol.
It works with HIKVISION_RSTP protocol but impossible to have access to motion detection (not supported).

When I add the ringbell in the NVR with hikvision protocol I have a message : Device Type Mismatch (image joined)

Note I have access to motion detection option with ivms 4200 but impossible to have video/image to draw a zone (possible with my old K1). I tried a lot of plugin,webrowser,ie-tab...

Any idea ?

Thanks

 

[trempa92]

Save this as .vbs and then install component

 

[Anakins]

Thanks a lot for this direct link to IE.

But I have always my problem with integration and the Device Type Mismatch on my new NVR v5.

 

[trempa92]

yeaaa v5 is new and new coming bugs are appearing day after day. Cant help with that. What you can do is add Motion detection on Door station and hope NVR will pick its settings, just add record schedule at motion.

Try to add it via onvif

 

[Anakins]

Yes I understood.

But it's a pitty because it works great before on my old NVR v4...

 

[trempa92]

Yes I understood.

But it's a pitty because it works great before on my old NVR v4...

Yea, either add via onvif or wait for an update fix