issue with Alarm-Inputs and movement to a preset

[thommymail]

Hello,

i have an issues with an DS-2DF8223I-AEL dome camera.
I have configure two alarm input, thera are configure NC from an PIR Sensor.
If the contact open then the camera should move to an preset an stay for 15 seconds on this preset.
After the 15 second’s the camera should move back to its home position.
At the moment, the camera moves to the preset and return immediately or the camera not even reached the present and go back to their home preset?

Where is the issue in the configuration?
It is possible give me any configuration tips for this issue?

Regard's
Thomas

 

[nayr]

dont know about hikvisions, but on my dahuas the option your looking for is called 'Anti Dither'

in this attached screenshot the alarm will go back to normal state 30s after the motion sensor goes idle.. do you have anything like that in your configs? Last Hikvision I was on the alarm setup seemed very lackluster compared to what I am used to.