Hi everyone,
I’m facing an issue with two Dahua IPC-HDW1530T-0280B-S6 cameras after a power outage occurred while I was updating the firmware. I managed to successfully reset one of the cameras using the pin shorting method, but the other one is not responding as expected.
The power LED on the non-working camera stays solid, even when resetting it. I’ve attempted to use the TFTP method to recover it, but I’m running into issues with finding the correct firmware. Despite searching online and contacting the manufacturer, I haven't had any luck pinpointing the right firmware version for this specific model.
The camera does respond to the TFTP connection; it shows up on my computer, but when I run the standard commands like dr, dk, du, dw, dp, dc, etc., the camera says that these commands are unknown.
Has anyone here encountered a similar issue? Or perhaps have a suggestion on the correct firmware for this model? Any tips or advice on how to proceed would be greatly appreciated!
Thanks in advance for your help!
I’m facing an issue with two Dahua IPC-HDW1530T-0280B-S6 cameras after a power outage occurred while I was updating the firmware. I managed to successfully reset one of the cameras using the pin shorting method, but the other one is not responding as expected.
The power LED on the non-working camera stays solid, even when resetting it. I’ve attempted to use the TFTP method to recover it, but I’m running into issues with finding the correct firmware. Despite searching online and contacting the manufacturer, I haven't had any luck pinpointing the right firmware version for this specific model.
The camera does respond to the TFTP connection; it shows up on my computer, but when I run the standard commands like dr, dk, du, dw, dp, dc, etc., the camera says that these commands are unknown.
Has anyone here encountered a similar issue? Or perhaps have a suggestion on the correct firmware for this model? Any tips or advice on how to proceed would be greatly appreciated!
Thanks in advance for your help!
