IVS issues

T

Tanga

n3wb
Nov 19, 2019
9
1
Australia
so I am trying to set up IVS periods. The ivs is trigging at times I dont want and sending notifactions to my phone during working hours I have set it up using the web services page. I have it deactivated the rules in the second picture to stop getting triggers all day long. Under smart plan I have IVS active. ANy ideas how to get just messages during the 1700 to 600 hours and not 24hours

1574290787469.png
1574290844149.png
 
I may not understand but the setting you have in the top image would trigger everything EXCEPT 0600 to 1700
 
hmmmm have to think about that...what camera model? Have you tried deleting the rule completely and rebooting the camera then set a new rule fro scratch?
What browser are you using to access the camera?
 
I have a few models listed below. I did try to delete the rule and reboot but I might have left the smart plan on so will try agian. I am using internet explorer to access the camera.
IPC-HDW1631EM
DH-SD1A203T-GN
IPC-HDW4631EM-AS
 
ok just removed the rules and smart plan and rebooted the system though auto maintainance. I reset the rules and the smart plan but its still doing it :mad:
 
You’re setting it in the camera itself right? Not the NVR or SmartPSS...i would remove on both of those as well.. I never configure anything via the NVR that I can set directly on the camera.
 
  • Like
Reactions: Tanga
well i think you just hit the nail on the head. I was doing it to the NVR but found this on the camera so when I was adding the rule it was making it 24hrs on the camera (pic is from the camera settings) 1574301123027.png
 
  • Like
Reactions: bigredfish
I find that if you set things in the camera itself first, the NVR will adopt it correctly. Doesn’t work well the other way around many times.
 
Thank you for your help Bigredfish :) i will play around with the nvr not to see it i can make camera1 activate the ptz camera to move to the set location
 
Don’t forget to select all the weekdays (M-F) when I’m assuming you’re at work. Then you won’t have to change the times form each day separately ( which may or may not have been your initial problem to begin with).
 
toolazyforalogin said:
Don’t forget to select all the weekdays (M-F) when I’m assuming you’re at work. Then you won’t have to change the times form each day separately ( which may or may not have been your initial problem to begin with).
Click to expand...
yes i had all the times selected correctly in the nvr but the cameras didnt sync and where running 24 hours a day
 
I’m able to set the PTZ to react to another camera’s event via my older XVR. Just dont make any changes to the camera settings except on the camera itself.
 
Last edited:
You must log in or register to reply here.
Top Bottom