Looking for network help on a Dahua N98A5N NVR

[techguypaul]

Just got a new Dahua N98A5N NVR and 16 port Dahua switch model-DH-LR2218-16ET-240
ATM I’m looking to configure NIC2 to create a separate subnet with DHCP, connect to the Dahua switch and pass this through to the cameras.
I’m assuming this is possible but so far I haven’t been able to figure this out and haven’t found any helpful documents.
Any guidance or documents would be much appreciated.

correction switch is DH-LR2218-16ET-240.

 

[techguypaul]

Looks like it’s not possible.
Mods can you move to NVR section or I’ll delete and repost.

 

[Didact74]

You would need to create the 2nd subnet (VLAN) on your gateway/router. Then you can use both NICs on the NVR independently.