Motion trigger not using the entire image

[dswingle]

I just installed blueiris in the past week and figuring out all of the different settings. On the motion sensor screen, I can't figure out how to have the motion sensor detect around the edges of the image (see image below). How do you adjust the motion sensor area to the whole image (I assume it is the blue box in the preview)?

 

[th182]

That's not the motion map. Check use zones and hot spots and you'll find the detection area under that edit button.


Sent from my iPhone using Tapatalk

 

[ajwitt]

What you are looking at is the size of something to reset the trigger - that is different than the motion sensor.