New NVR and cams one showing "Bad Gateway"

1

18032190

n3wb
Nov 7, 2019
20
6
CA
Just got a new system 6 cams and the new 7608 NVR with the new confusing (to me) 5.0 firmware on it. Managed to get all 5 cams up and running and can now get into the individual cam via the nvr link online. But one cam which happens to be a PTZ, the 4MP mini dome is online and working, but I need to get inside the cam for additional settings. When I click the link it gives me in the NVR, it states "Bad Gateway". I ran it through SADP by itself and came up fine, could get inside no problem. But once hooked back up to NVR, no go. Any ideas?

1723850002394.png
 
Did they really change the port number for virtual host on 5.0 to 80????

If you open ip address of your NVR and add port 65001 as a channel 1 and continue adding +1 for another channel, is that working now?

If not, can you check in Network settings under 'Other' if checkmark is applied to Virtual host
 
The NVR 5.0 menu is so difficult to find things versus the older versions. I did manage to find the Virtual Host button, enabled it, and now the cameras show with 65001 and so on. However, when you try to open the other 5, they all get into the Cam itself, but still not the PTZ, says "Bad Gateway". But all are working fine up and running and can be seen through the app remotely, just cant get into the PTZ menu which I need for smart tracking and other detailed features

1723909190695.png
 
You must log in or register to reply here.
Top Bottom