I'm pretty experienced with networking, Blue Iris and cameras in general, but new-ish to these NVR things
and their 'quirks'...
I have a Hikvision DS-7608NI-E2 NVR (fw vers 3.3.601) set up on the test bench with a few cams. Not all cams have the same aspect and one is turned sideways (corridor mode).
one is a 3MP (4x3 aspect), one is 2MP (1080p @ 16:9 aspect), and the third is a 3MP in corridor mode (4x3 aspect, but sideways.)
Yet the NVR live view shows them all the same aspect. I find the config/local/live-view-parameters section has radio buttons for auto/4x3/16x9, but that seems to apply to the entire image (all cams).
Is there no way to specify/correct the aspect for individual cameras? As is, there's always one or more cams displayed at the wrong aspect (stretched one way or another to fit the frame)
Do they really assume that ALL our cams have the same aspect? You'd think the software could determine the aspect of the stream and 'do the right thing' with it (like BI does...)
Thanx for any insight on this issue. Paul.
and their 'quirks'...
I have a Hikvision DS-7608NI-E2 NVR (fw vers 3.3.601) set up on the test bench with a few cams. Not all cams have the same aspect and one is turned sideways (corridor mode).
one is a 3MP (4x3 aspect), one is 2MP (1080p @ 16:9 aspect), and the third is a 3MP in corridor mode (4x3 aspect, but sideways.)
Yet the NVR live view shows them all the same aspect. I find the config/local/live-view-parameters section has radio buttons for auto/4x3/16x9, but that seems to apply to the entire image (all cams).
Is there no way to specify/correct the aspect for individual cameras? As is, there's always one or more cams displayed at the wrong aspect (stretched one way or another to fit the frame)
Do they really assume that ALL our cams have the same aspect? You'd think the software could determine the aspect of the stream and 'do the right thing' with it (like BI does...)
Thanx for any insight on this issue. Paul.