Only trip wire emails on one camera

[bertnl]

Hi I have a DHI-NVR4208-8P-4KS2 (V4.001.0000003.1, Build Date: 2020-08-13 )
and 4 camera's
IPC-T5442T-ZE 4MP Starlight IR Vari-focal Eyeball Network Camera
V2.840.15OG00D.0.R, Build Date: 2022-08-18

I have all 4 camera's cofigured the same settings and I have tripwires on all camera's in IVS
Now For some time I only receive emails for camera 1 and none for the other camera's
I remeber I have seen some mails in the past but I am not sure

I see the small video clips that are automatically copied to my NAS for all those camera's
So the tripwares are activated as expected but no mail is sent
Where could I go wrong?

 

[bertnl]

no one with a clue?

 

[jarrow]

If you're receiving emails from one camera it means the email settings are correct.
In the NVR, go to AI -> Parameters -> IVS -> Channel 2/3/4 and make sure that for each tripwire you have 'Send email' checked. This setting is under 'More settings' when you click on an IVS rule.

In Dutch :

 

[bertnl]

THis was the info that I needed to fix it!! Thanks!
I have been looking quite some time to fix this!

 

[bertnl]

@EMPIRETECANDYIs there a limit in the amout of tripwires in the configuratiion?
What is the limmit and is that for the NVR of for every individual camera?
I see a message "reached max capacity,"

 

[bertnl]

I still am missing Tripwires
I have 4 camera's and I have set the same settings for all camera's.
There are a tripwire set for each camera with exatly the same settings and enabled 24/7
on two of the camera I see the trippin (green blinking ) on the other cameras nothing happens No tripping at all.

I see myself in the recorded video crossing the line but I do not seet the tripping of those two other camera's
Also when I go in the search view I see nothing.

Also tried motion detection but als that is not detected on those camera's
I do all the settings via the webpage of the NVR. From there I gp the the web page of that camera to do the individual event settings for each camera