So in trying to keep my office clean I threw the box away with the coupler for my camera. Now that the exterior work is done I am starting to look about mounting but can't do that with out the coupler. Anyone know where to get another for a reasonable price? One that will of course match the camera? It is a Hikvision rebrand Annke C800.
Replacement water proof connectors
- Thread starter erylflynn
- Start date
Take a look at these 2 types:
1) Finished/premade RJ45 modular can NOT go through this connector due to limited cap hole size.
2) Finished RJ45 modular can pass through without being removed; Inner diameter of boot is 19mm
Bottom line: even if you find the correct fitting, if that connector is exposed to the elements, I suggest you:
1) Finished/premade RJ45 modular can NOT go through this connector due to limited cap hole size.
2) Finished RJ45 modular can pass through without being removed; Inner diameter of boot is 19mm
Bottom line: even if you find the correct fitting, if that connector is exposed to the elements, I suggest you:
- Use dielectric grease on both the male RJ-45 and in the female where it connects.
- Wrap the entire junction with self-fusing rubber tape, don't be stingy, go past barrel connector and on out pigtail a couple of inches on both ends.
- Over-wrap all that self-fusing rubber tape TIGHTLY with 3M 33+ or 88 to aid and speed up the curing process but it will remain on.