Hey guys,
On hikvision firmware 5.4.3 I used the below http address to get to an image for my Home automation to display. Now that I have updated to firmware v5.5 it no longer works.
I think this is called RTSP? If so there is "RTSP Authentication" on the System>Security>Authentication config page but when I try to set a value I get "Parameter Error" - Options are Disabled or basic
So I figured it was a weird config error after upgrade, so I reset the unit and deleted it from my NVR.
When the camera comes up and its on its default IP config, in the RTSP Authentication config it shows 2 different options, digest or basic. So I pick one of those, set the IP config and restart it.
When it comes back up it shows the Disabled or basic options again and throw the parameter error when I try and set it.
Any ideas on how I fix this up?
Cameras
DS-2CD2042WD-I
DS-2CD2342WD-I
http://Camera.IP.address.here/Streaming/channels/1/picture
On hikvision firmware 5.4.3 I used the below http address to get to an image for my Home automation to display. Now that I have updated to firmware v5.5 it no longer works.
I think this is called RTSP? If so there is "RTSP Authentication" on the System>Security>Authentication config page but when I try to set a value I get "Parameter Error" - Options are Disabled or basic
So I figured it was a weird config error after upgrade, so I reset the unit and deleted it from my NVR.
When the camera comes up and its on its default IP config, in the RTSP Authentication config it shows 2 different options, digest or basic. So I pick one of those, set the IP config and restart it.
When it comes back up it shows the Disabled or basic options again and throw the parameter error when I try and set it.
Any ideas on how I fix this up?
Cameras
DS-2CD2042WD-I
DS-2CD2342WD-I
http://Camera.IP.address.here/Streaming/channels/1/picture