Sheet Rock Blade/tool

[MartyO]

1) is there a high quality sheet rock tool for cutting strips out of the sheet rock for running 2 and 4 wire cables?

2)and does anyone make a flat ethenet cable with solid copper that can be also put in notch strips made in sheet rock ?

3) if a flat solid copper exists, can it be used in a POE setup legally (to code)?


Thanks in advance.

 

[vector18]

https://www.milwaukeetool.com/power-tools/cordless/2426-22

- - - Updated - - -

http://www.monoprice.com/product?c_id=102&cp_id=10208&cs_id=1020810&p_id=9553&seq=1&format=2

 

[MartyO]

https://www.milwaukeetool.com/power-tools/cordless/2426-22

- - - Updated - - -

http://www.monoprice.com/product?c_id=102&cp_id=10208&cs_id=1020810&p_id=9553&seq=1&format=2

Thnks, I have similar tool from lowes, but didn't think of using it I guess I could shim with a long piece of wood, so it doesn't go beyond sheet rock back side and doesn't hit plumbing or electrical lines. also didn't know about monoprice thks again

 

[42etus]

That cable from Monoprice is only 30 guage. That's pretty light for any poe application.

 

[alastairstevenson]

It's just a patch cable - the sort of thing you'd use from a PC or other device to the RJ45 wall outlet in an office or shop or factory, not rated for the full 100m length but really handy and flexible for that last short run.

 

[42etus]

Granted, but the OP mentioned using it for poe applications. 30 gauge is too small for poe use. Cat 5 cable is 24 gauge and cat 6 is 23 gauge. Quite a difference.

 

[MartyO]

found this info: thanks for the replies:

http://www.cirris.com/learning-center/calculators/133-wire-resistance-calculator-table

http://r.duckduckgo.com/l/?kh=-1&ud...uploads/fckeditor/file/Calc_PoE_PowerLoss.pdf