Im setting up my friends NVR, got all the cameras connected and recording. I just left all the cameras the default names (ex Camera 1, Camera 2) until my friend was around to tell me what he wanted them labeled as. We renamed them to what they are and then none of them would reconnect back to the QNAP.
I have setup and maintained about 10 QNAP NVRs mainly the VS-2212 Pro+ and never had this problem..
I have tried setting up the Qnaps config to use different hikvision camera profiles other than the one it really is, Used to have to do this with newer cameras until QNAP got them added to the next firmware update..
Setup Specs:
Hikvision Turret 4MP DS-2CD2342WD-I
Qnap VS-2212 Pro+ FW: 5.1.1 - 20170607
Cisco SG200-26FP Switch
Any ideas to try?
After leaving his house the only thing i could think of i didn't try was updating the cameras firmware.
EDIT:
Restarting cameras somehow fixed it..
I have setup and maintained about 10 QNAP NVRs mainly the VS-2212 Pro+ and never had this problem..
I have tried setting up the Qnaps config to use different hikvision camera profiles other than the one it really is, Used to have to do this with newer cameras until QNAP got them added to the next firmware update..
Setup Specs:
Hikvision Turret 4MP DS-2CD2342WD-I
Qnap VS-2212 Pro+ FW: 5.1.1 - 20170607
Cisco SG200-26FP Switch
Any ideas to try?
After leaving his house the only thing i could think of i didn't try was updating the cameras firmware.
EDIT:
Restarting cameras somehow fixed it..
Last edited: