I have read through the Sub Stream Guide and I understand the steps required to configure for sub stream use. However, I get stuck where it says to "Go to the Network IP camera configuration panel". I am unable to find this configuration panel in any of the camera settings. Looking at the Blue Iris Version 5 documentation, the only place this panel appears is when adding a new camera. Is it possible to edit the camera settings and set up the sub streams without deleting and then adding the camera as new?
Trying to Configure Blue Iris For Sub Stream Use
- Thread starter knavekid
- Start date
-
- Tags
- configuration sub stream
Never mind. I found it. For others who might encounter this issue, right-click on the desired camera display and select Camera Settings. Then select the "Video" tab. Under "Device type", the Network IP bullet is selected and the device IP address is shown. To the right of the IP address is a "Configure..." button. Click on that button to open the "Network IP camera configuration" panel.
