Just setup two of the Lite Beam 5 GHz radios. Most impressed.
What is the suggested "Wireless" setting field for "Channel Width". Choices range from 10 to 80 MHz.
As a test, used a 20 MHz "Channel Width" with a 24 port POE switch and 9 Dahua cameras on one end of the RF link. The other RF link is connected to a Blue Iris computer. Camera bandwidth at 84 Megs with available bandwidth at 126 Megs. Perfect images.
The link was tested in the office without the reflectors (dish) attached. Only the feed horns on both.
As a side note, looked at a dozen You Tube videos on setup. Most were not worth watching. However, the below, even without audio was right on. Short and to the point with the correct settings. There may be others out there, but did not find them.
Please suggest any additional settings, for use with Dahua cameras, that will improve the system.
What is the suggested "Wireless" setting field for "Channel Width". Choices range from 10 to 80 MHz.
As a test, used a 20 MHz "Channel Width" with a 24 port POE switch and 9 Dahua cameras on one end of the RF link. The other RF link is connected to a Blue Iris computer. Camera bandwidth at 84 Megs with available bandwidth at 126 Megs. Perfect images.
The link was tested in the office without the reflectors (dish) attached. Only the feed horns on both.
As a side note, looked at a dozen You Tube videos on setup. Most were not worth watching. However, the below, even without audio was right on. Short and to the point with the correct settings. There may be others out there, but did not find them.
Please suggest any additional settings, for use with Dahua cameras, that will improve the system.