Hi,
I bought a new Wanscam HW0046, personal i think this ip cam is not bad, everything look really fine and good
but there are some bug with the setup (wonder if i can hack it?).
I had voice out with the CSO but reply was so so... (they ask me to do factory reset) i will try that later.
My issue was the video recording setup.
It happen only with Second Stream setting which is for 640 X 480,
after I change to my own setting. after a while recording the video setting jump back to default setting (which caused the video and audio is not match) My setting was as show below, i find this is the best as the video and audio play smoothly
Bit Rate: 3000
Maximum frame rate: 25 fps
Key frame interval: 25 fps
Default setting (This setting will cause video and audio not match, audio faster than video while doing normal play.)
Bit Rate: 1024
Maximum frame rate: 20 fps
Key frame interval: 40 fps
I bought a new Wanscam HW0046, personal i think this ip cam is not bad, everything look really fine and good
but there are some bug with the setup (wonder if i can hack it?).
I had voice out with the CSO but reply was so so... (they ask me to do factory reset) i will try that later.
My issue was the video recording setup.
It happen only with Second Stream setting which is for 640 X 480,
after I change to my own setting. after a while recording the video setting jump back to default setting (which caused the video and audio is not match) My setting was as show below, i find this is the best as the video and audio play smoothly
Bit Rate: 3000
Maximum frame rate: 25 fps
Key frame interval: 25 fps
Default setting (This setting will cause video and audio not match, audio faster than video while doing normal play.)
Bit Rate: 1024
Maximum frame rate: 20 fps
Key frame interval: 40 fps
Last edited by a moderator: