Brian-connect
n3wb
I’m hoping someone can help. Purchased 2 WDReadyview systems ( wanted to make (1) 8 cam sys and was cheaper to buy 2 whole sets) started out OK, set it up just direct connected to NVR. Remote access from app was good. 1st round only had 3 cams up but had 4 link lights on NVR ports 1-4. Started switching cams and ports around to see if port or cam was bad. Now I have 4 link lights on NVR and no videos. My viewing table shows “no link” on all channels. Round 2 wiped NVR started over. Get 4 link lights, app works, “no link” on view table/screen. This is a POE sys, no “reset” button on cams. WD tech support was no help, they make you contact Microcenter. Microcenter support says wipe, redo... I say ok and then I tell them no cams come up, they say hard restart.... I say ok and again no cams come up. Then they say return to store! I tried both NVRs, I have the same outcome. I am extremely aggravated, disappointed, completely let down by WD and Microcenter. I then went back to Microcenter and talked with service desk tech, he said contact WD as they don’t work on the IP cam sys and thus my circle jerk continues. I researched on line and if I see one more time “easiest sys to set up” I may explode. I have tried factory reset/redo many times...sometimes after factory reset I will get (1) cam to come up now, but still the other 3 say no link on view table, I do have 4 link lights on NVR ports 1-4 per usual. I do connect NVR direct to router, I connect cams to NVR ports 1-4, I startup NVR, I navigate NVR via mouse and monitor, I select dhcp, and pretty much continue to get same results. Hoping someone somewhere will see this and give me the solution...... I fear it will be “return to store”
I appreciate any advice. Thank you- Brian
I appreciate any advice. Thank you- Brian