SD49225T-HN install question.
- Thread starter motoolfan
- Start date
nayr
IPCT Contributor
hmjgriffon
Known around here
Unfortunately I'm in a one story with no attic so it might be low enough that you could jump up and tap the bottom, may have to rig something to get it higher, or I was considering putting it on the edge of the roof, then I wouldn't be able to see under the roof along the walkway in front of the house and stuff, guess I'll see when it gets here.
Sent from my Nexus 6P using Tapatalk
Sent from my Nexus 6P using Tapatalk
Thanks for the info, I know it'll be a lil while before the camera is here. Just getting prepped, Will have the cable ran in a week or so.
hmjgriffon
Known around here
you only need a POE cable unless you plan to connect a mic, speaker, or something to one of the alarm inputs/outputs.
nayr
IPCT Contributor
a poe cable really? go have another Coffee
hmjgriffon
Known around here
nayr
IPCT Contributor
hmjgriffon
Known around here
I just ordered one from andy yesterday too, i have a question about poe. My nvr supplies poe not poe+ so i am figuring i need to run power wire to cam location plus cat5. If they are both hooked up will that overpower cam? Or can i add poe+ inserter between nvr and cam? Also does anyone know what size the threads are on top of cam? I would like to mount camera as close to soffet as possible thinking i could something at hd that would it would screw into and that would go directly on soffet. I have seen pipe in accessories but its like 9 inches long looking for around 2-3 inches long.
Something like this.
Something like this.
Attachments
Can't you just add one of these which will allow you to run the single CAT cable to the camera - Amazon.com: TRENDnet Gigabit Power over Ethernet Plus (PoE+) Injector, TPE-115GI: Computers & Accessories
As an Amazon Associate IPCamTalk earns from qualifying purchases.
hmjgriffon
Known around here
similar to what I am using on my PTZ.
As an Amazon Associate IPCamTalk earns from qualifying purchases.
I understand using injector, like i asked will it overpower ptz and burn it up or does it regulate itself? Dont know if i am overthinking this...
nayr
IPCT Contributor
Active PoE requires a PoE device on it to provide power, its supposed to be safe to plug any non-poe device into that port becuase it wont signal a need for power..
If you chain a PoE+ Midspan/Injector off your PoE NVR, it wont activate PoE on the port going to the Midspan/Injector, but that will activate PoE downstream if a PoE Device is plugged into the injector.. with a PoE+ Injector you can pull up to 25.5W off that supply before overloading it.
Most NVR's will provide PoE+ unless you went really cheap or old.
If you chain a PoE+ Midspan/Injector off your PoE NVR, it wont activate PoE on the port going to the Midspan/Injector, but that will activate PoE downstream if a PoE Device is plugged into the injector.. with a PoE+ Injector you can pull up to 25.5W off that supply before overloading it.
Most NVR's will provide PoE+ unless you went really cheap or old.