I have a dahau nvr.in main menu settings go to camera. Then remote , added device ( mine is at the 2 nd half of screen . Find your camera in added device , hit modify. Then find decode buffer and move it to real time. Hope this works for you had a problem since.
Hi there Curt, and thanks so much for kindly replying.
I also have a Dahua NVR, but I think you must have a direct hookup to the NVR hardware itself as I don't recognise some of the settings labels you have quoted. However, you provided me with enough info to be able to find the relevant section using my Easy Viewer for Chrome browser plug-in app. In case anyone else is having the same issues, I'll repeat the steps I took below, together with a screen grab:
Select SETUP tab; Choose REGISTRATION; go down to the device listing in 2nd half and select the pencil icon (not shown in screen grab as it is obscured by the Modify pop-up); then select the Decode Buffer drop-down to reveal Default/Real time/Fluent options. Mine was on Default setting, so have now changed it to Real time, as per Curt's suggestion. Fingers crossed!
PS. I also tried doing the same thing using the SmartPSS software, but could not for the life of me find anything to modify the DECODE BUFFER. All the other settings in the Modify panel above were available in the Device Config/Camera/Remote tab, but not that one! I looked all over the place, but simply had to give up. If anyone knows where it can be found, I would appreciate the heads up! But at least I was able to use the Chrome browser Easy Viewer plug-in instead.
Nigel