I know I can use camera groups to cause motion detection on one camera to trigger another PTZ camera to move to a particular preset - I'm just wondering if there is a way to have two different cameras to trigger the same PTZ camera to move to a specific preset each?
Basically I am aiming to install a PTZ at the front of my property and would like to trigger it to a preset pointing at the porch (if the porch cam is triggered), or to point it at a preset looking at the driveway (if my camera further back down the driveway is triggered). Does anyone know if this is possible to do? From looking at some other threads it sounds like what I may need to do is set up a "clone" of the PTZ camera which is just used for PTZ via a camera group - does that sound right? Presumably this would only need a sub feed from the camera and no recording - just the ability to cause the clone (and along with it the "proper" camera) to move to the required preset?
Basically I am aiming to install a PTZ at the front of my property and would like to trigger it to a preset pointing at the porch (if the porch cam is triggered), or to point it at a preset looking at the driveway (if my camera further back down the driveway is triggered). Does anyone know if this is possible to do? From looking at some other threads it sounds like what I may need to do is set up a "clone" of the PTZ camera which is just used for PTZ via a camera group - does that sound right? Presumably this would only need a sub feed from the camera and no recording - just the ability to cause the clone (and along with it the "proper" camera) to move to the required preset?
) didn't appear to work with the suggested commands (which I assume would for a standard ONVIF?). After a bit more searching on this site though (now that I knew what I was looking for thanks to your reply) I stumbled across