Perhaps use Plastidip?FYI this paint did not bond very good to the cameras metal surface and scratched very easily. Next time I'm going to try clean surface with a good solution and use etching primer first. I May even try a different paint.
Hi @SecuritySeekerPerhaps use Plastidip?
Doesn't the 2231 exist in black like the 5231?
How did you tape off the glass which such precision?some pics of a paint job I'm doing for a local install. need 3 cams painted black.
View attachment 49447
tape it and a light sanding with 220 grit
View attachment 49448
clean it off and paint.
View attachment 49449
Used some Vaseline for the small sensor hole. Q-tip to get it out and a paint pen for touch ups.
View attachment 49450
View attachment 49452
The yellow knife in pic (razor blade) and a steady hand.How did you tape off the glass which such precision?
You need to let it dry for about three weeks. Rustoleum paint is dry to the touch in about an hour, but it actually takes a long freaking time for it to reach a full cure. The paint is oil based, when it dries to the touch, it is the solvents that have evaporated off. It takes a long time (two or three weeks) at ambient temperatures to fully cure. Ignore the instructions, they're useless.FYI this paint did not bond very good to the cameras metal surface and scratched very easily. Next time I'm going to try clean surface with a good solution and use etching primer first. I May even try a different paint.
I have had very good luck with Krylon spray paint and primer. I painted a bunch of domes and they have held up really well for the past few yearsFYI this paint did not bond very good to the cameras metal surface and scratched very easily. Next time I'm going to try clean surface with a good solution and use etching primer first. I May even try a different paint.