HKVS # reset
resetting ...
System startup
Uncompress.............Ok
System startup
U-Boot 2010.06-403449 (Jun 27 2018 - 14:29:28)
spi_solve_flash_lock_qe_enable(379): Error: Disable Quad failed! reg: 0x2
SPI Nor: 16MB
DDR: 128MB
[Uboot] In release mode!
Hit Ctrl+u to stop autoboot: 0
MAC: <I removed this>
eth0 : phy status change : LINK=UP : DUPLEX=FULL : SPEED=100M
|RCV UDP pack timeout|
TFTP server not found
booting from sys part...
Load kernel to 0x80007fc0 ...
Done!
Succeed!
## Booting kernel from Legacy Image at 80007fc0 ...
Image Name: Linux-3.18.20-e3
Image Type: ARM Linux Kernel Image (uncompressed)
Data Size: 2893367 Bytes = 2.8 MiB
Load Address: 80008000
Entry Point: 80008000
XIP Kernel Image ... OK
OK
Starting kernel ...
[ 0.000000] Booting Linux on physical CPU 0x0
[ 0.000000] Initializing cgroup subsys cpu
[ 0.000000] Linux version 3.18.20 (root@HIK-RD-CI-Frontend) (gcc version 4.9.4 20150629 (prerelease) (Hisilicon_v500_20150831) ) #2 Wed Jun 27 14:54:46 CST 2018
[ 0.000000] CPU: ARM926EJ-S [41069265] revision 5 (ARMv5TEJ), cr=0005317f
[ 0.000000] CPU: VIVT data cache, VIVT instruction cache
[ 0.000000] Machine model: E3 Board
[ 0.000000] Memory policy: Data cache writeback
[ 0.000000] Built 1 zonelists in Zone order, mobility grouping on. Total pages: 16764
[ 0.000000] Kernel command line: console=ttyAMA0,115200 KRN_PRT=pri mdio_intf=rmii phy_addr=3 mac=<removed> rst_flag=0 bld_rev=403449 trspt_mode=0x0 flash_type=spinor flash_size=16777216 devtype=0x22c1c
[ 0.000000] PID hash table entries: 512 (order: -1, 2048 bytes)
[ 0.000000] Dentry cache hash table entries: 16384 (order: 4, 65536 bytes)
[ 0.000000] Inode-cache hash table entries: 8192 (order: 3, 32768 bytes)
[ 0.000000] Memory: 61072K/67584K available (3034K kernel code, 145K rwdata, 872K rodata, 1412K init, 242K bss, 6512K reserved)
[ 0.000000] Virtual kernel memory layout:
[ 0.000000] vector : 0xffff0000 - 0xffff1000 ( 4 kB)
[ 0.000000] fixmap : 0xffc00000 - 0xffe00000 (2048 kB)
[ 0.000000] vmalloc : 0xc4800000 - 0xff000000 ( 936 MB)
[ 0.000000] lowmem : 0xc0000000 - 0xc4300000 ( 67 MB)
[ 0.000000] modules : 0xbf000000 - 0xc0000000 ( 16 MB)
[ 0.000000] .text : 0xc0008000 - 0xc03d8e94 (3908 kB)
[ 0.000000] .init : 0xc03d9000 - 0xc053a000 (1412 kB)
[ 0.000000] .data : 0xc053a000 - 0xc055e760 ( 146 kB)
[ 0.000000] .bss : 0xc055e760 - 0xc059b070 ( 243 kB)
[ 0.000000] SLUB: HWalign=32, Order=0-3, MinObjects=0, CPUs=1, Nodes=1
[ 0.000000] NR_IRQS:16 nr_irqs:16 16
[ 0.000000] VIC @fe040000: id 0x00641190, vendor 0x41
[ 0.000028] sched_clock: 32 bits at 3000kHz, resolution 333ns, wraps every 1431655765682ns
[ 0.000691] Console: colour dummy device 80x30
[ 0.000746] Calibrating delay loop... 398.13 BogoMIPS (lpj=1990656)
[ 0.050025] pid_max: default: 32768 minimum: 301
[ 0.050203] Mount-cache hash table entries: 1024 (order: 0, 4096 bytes)
[ 0.050229] Mountpoint-cache hash table entries: 1024 (order: 0, 4096 bytes)
[ 0.051515] CPU: Testing write buffer coherency: ok
[ 0.052294] Setting up static identity map for 0x802e4640 - 0x802e4698
[ 0.055667] VFP support v0.3: not present
[ 0.056321] pinctrl core: initialized pinctrl subsystem
[ 0.064882] NET: Registered protocol family 16
[ 0.066391] DMA: preallocated 256 KiB pool for atomic coherent allocations
[ 0.080472] Serial: AMBA PL011 UART driver
[ 0.080773] 12100000.uart: ttyAMA0 at MMIO 0x12100000 (irq = 21, base_baud = 0) is a PL011 rev2
[ 0.334041] console [ttyAMA0] enabled
[ 0.347416] ssp-pl022 12120000.spi: ARM PL022 driver, device ID: 0x00800022
[ 0.354517] ssp-pl022 12120000.spi: mapped registers from 0x12120000 to fea20000
[ 0.363475] ssp-pl022 12121000.spi: could not find pctldev for node /soc/pinmux@12040000/spi1_pmux, deferring probe
[ 0.374019] amba 12121000.spi: Driver ssp-pl022 requests probe deferral
[ 0.381440] usbcore: registered new interface driver usbfs
[ 0.387081] usbcore: registered new interface driver hub
[ 0.392579] usbcore: registered new device driver usb
[ 0.398383] himci: mmc host probe
[ 0.570134] himci: mmc host probe
[ 0.740141] himci: mmc host probe
[ 0.910437] eMMC netlink init ok.
[ 0.915439] Switched to clocksource arm,sp804
[ 0.931171] NET: Registered protocol family 2
[ 0.937472] TCP established hash table entries: 1024 (order: 0, 4096 bytes)
[ 0.944514] TCP bind hash table entries: 1024 (order: 0, 4096 bytes)
[ 0.951001] TCP: Hash tables configured (established 1024 bind 1024)
[ 0.957565] TCP: reno registered
[ 0.960813] UDP hash table entries: 256 (order: 0, 4096 bytes)
[ 0.966749] UDP-Lite hash table entries: 256 (order: 0, 4096 bytes)
[ 0.973432] NET: Registered protocol family 1
[ 2.665423] mmc0 power register success!
[ 2.669525] mmc1 power register success!
[ 2.673449] mmc2 power register success!
[ 2.677414] usb0 power register success!
[ 2.682997] futex hash table entries: 256 (order: -1, 3072 bytes)
[ 2.708780] squashfs: version 4.0 (2009/01/31) Phillip Lougher
[ 2.715388] jffs2: version 2.2. (NAND) © 2001-2006 Red Hat, Inc.
[ 2.723198] msgmni has been set to 119
[ 2.729552] io scheduler noop registered (default)
[ 2.740857] pinctrl-single 12040000.pinmux: 66 pins at pa fe940000 size 264
[ 2.748468] pinctrl-single 12040800.pinconf: 76 pins at pa fe940800 size 304
[ 2.768258] brd: module loaded
[ 2.773911] hisi-sfc hisi_spi_nor.0: all blocks is unlocked.
[ 2.779708] hisi-sfc hisi_spi_nor.0: w25q128 (16384 Kbytes)
[ 2.795798] Creating 8 MTD partitions on "hi_sfc":
[ 2.800622] 0x000000000000-0x000000060000 : "bld"
[ 2.806941] 0x000000060000-0x000000070000 : "env"
[ 2.812966] 0x000000070000-0x000000080000 : "enc"
[ 2.819196] 0x000000080000-0x000000090000 : "sysflg"
[ 2.825695] 0x000000090000-0x0000000a0000 : "dpt"
[ 2.831783] 0x0000000a0000-0x0000003f0000 : "sys0"
[ 2.838054] 0x0000003f0000-0x000000ed0000 : "app0"
[ 2.844260] 0x000000ed0000-0x000001000000 : "cfg0"
[ 2.851492] libphy: hisi_femac_mii_bus: probed
[ 2.915490] hisi-femac 10050000.ethernet: phy_id=0x001cc816, phy_addr=3, phy_mode=rmii
[ 2.925329] PPP generic driver version 2.4.2
[ 2.930078] PPP BSD Compression module registered
[ 2.934807] PPP Deflate Compression module registered
[ 2.939945] PPP MPPE Compression module registered
[ 2.944766] NET: Registered protocol family 24
[ 2.949334] ehci_hcd: USB 2.0 'Enhanced' Host Controller (EHCI) Driver
[ 2.955917] ehci-platform: EHCI generic platform driver
[ 2.961438] ehci-platform 10120000.ehci: EHCI Host Controller
[ 2.967311] ehci-platform 10120000.ehci: new USB bus registered, assigned bus number 1
[ 2.975723] ehci-platform 10120000.ehci: irq 31, io mem 0x10120000
[ 2.996524] ehci-platform 10120000.ehci: USB 2.0 started, EHCI 1.00
etc etc etc