Recent content by bertsirkin

I recently updated to version 5.8.3.3. Since updating, I no longer get "clips". All of the recordings are between 4 and 8 hours. I checked the "recording" tab of BI and see that all my cameras now have a "Combine or cut video each: 8 hrs, 0 mins 4gb". I haven't change this, but suspect this is...

I always knew that Wifi wasn't the best route - most of my cameras are wired ip cameras, but some just can't be wired easily. Thanks for the detailed explanation. bert

Thanks - I should have - I just did. Bert

Wyze removed the RTSP firmware and I don't think it works with the v3 cameras, which is what I have. I have enough issues with Wyze cameras, and just would like to eliminate wyze if I can! bert

I thought of that, but I have about 5 of these cameras, and it would be a lot simpler just to do wifi cameras. bert

Thanks for the suggestions - I should have stated that I was looking for 2k cameras (not 2mp). THose cameras look good, but I want something a bit higher resolution. bert

I have a few locations I currently have Wyze cameras. The Wyze cameras haven't been very reliable plus, I can't view them in Blue Iris, and would like to. I have HikVision wired cameras now, but have some locations where I can't easily run cable to and am looking for a wifi camera that has the...

This is happening on all of my cameras - the network is hard-wired fiber, and I rarely lose connection. Nothing, as far as I know, is set to reboot. bert

I have a dedicated computer to BI that never goes into sleep or hibernation mode. I have trigger audio set up for my 6 cameras (using morse code to tell them apart). The audio works for about a half day and then stops. The cameras continue to trigger and record video, but no audio is heard after...

Not sure what you're telling me. I do have each camera assigned to a group (indoor vs outdoor). bert

I never noticed that option before - I'm guessing it's a new option as I didn't have any issues with the September, 2022 version I was running, but upgrading to a newer version must have automatically enabled that with no cameras selected. Thanks! bert

That was it! Somehow, with the new version of BI, the "limit to camera groups" was checked on my existing user id. All is well - thanks!

If that was the case, I wouldn't think it would work with the older version of BI. Here's the user properties for the user logging into UI3: bert

With version 5.6.1.3 installed, the UI3 "about" menu indicates the same version. When I update to the latest stable version (5.6.6.1), I can't check the UI3 version in the browser, but in the "C:\Program Files\Blue Iris 5\www\ui3" folder, the 2 latest files are ui3.js and ui3.css, dated 11/29/22...

Any suggestions?