Recent content by c.grex

doesnt seem to have any now. But he does have: https://www.dahuasecurity.com/asset/upload/product/20180706/SD42C212T-HN(-S2)_Datasheet_20180705.pdf is this the same camera but recessed?

Broken for me too! Can’t connect to NVR. I’ve downloaded the ‘lite’ version and that will connect fine. The problem with iOS is you can’t revert to a older app! Hope they fix it ASAP.

Thanks, in short it’s not anywhere as easy as the newer NVR’s!

I have a new Dahua 5216 NVR and you can access each via the web interface. I also have a older NVR4216, is there a way to do it with this NVR?

I use iDMSS plus a lot on my mobile. Is there way to see IVS recordings? I only seem to be able to see motion detection recordings.

I’ve just upgraded my NVR to a nvr5216-16p-4ks2. I previously had a older NVR4208p. This had no way to access the cameras menu’s or no IVS support etc. All settings where done on the NVR. The 5216 obviously has the short cut on the config screen to log directly into camera to get to all the...

Is this the same camera on Empire Store? Aliexpress.com : Buy SD22204T GN 1080p 2mp mini PTZ IP Camera full hd 4x optical 16xdigital network ptz ceiling mini dome camera, free shipping from Reliable Surveillance Cameras suppliers on Empire Technology Co., Ltd I've had a price direct from Andy...

Just wondering if anybody could advise? I’m thinking of getting this camera or another suitable for outside in same price range. I currently have a Dahua NVR4208-8P (bought 2014). Would This camera run from a Cat6 run I already have or would I need more power?

Sorry for for the late reply. I have had the condensation issue again over the past two days and have again stripped the camera down and rechecked all the seals, again I can't see why it's letting in that little bit. I'll give it another go for the next few days (No rain expected for 2 days)...

three little grub screws. 1. stops the lower ring from unscrewing off, this is the mounting that goes on to the wall. 2.stops the the outer casing from spinning round (this is the bit that screws onto the base and inside this is where the main camera ball goes) 3. stops the ball from spinning...

The main part of the camera, the ball is split down the middle by undoing three screws on the back. The seal around the 'split' is a rubber one and seems very good and i can't see how water can get in. The mic is sealed to the front casing with what looks like silcone and the seal seems good...

No thankfully it doesn't have the pigtail! I've managed to fit all the connections under the bottom of the dome so you can only see the cat5 going in.

I've had it open and can't see where it's got in? Dried it out and give it another go.

No leads for a mic or speaker. Can't say I've really tested the speaker much, but it seem to pick up a slight breeze here in the location it's installed, so seems fairly senstive. I'm not really bothered about the mic anyway.

Installed my HDW4300C yesterday and we had a bit of rain over night and........