Recent content by epyscs

  1. E

    Questions re new setup from Andy

    Hi Folks, I recently got a setup of T5442T-ZE's cameras paired with a NVR5216-4kS2 and post install I have a few queries I am hoping you good folk might be able to help with? Firstly, for some reason there are no motion detection yellow marks on the playback screen on the NVR playback. I...
  2. E

    Help - robbed during lockdown

    The main issue we had down there was kids getting pissed up and smashing bottles etc, so most of the CCTV has been focused on that issue. The motors we thought were stolen last time by someone getting access while we were open and hiding the motors in the bush and we didnt notice. We are now...
  3. E

    Help - robbed during lockdown

    Hey Guys, really appreciate the continued ideas on this one. I think we will certainly do the PIR route linked to the camera. A camera will be going into the shed and I have to admit, I almost want the scenario where they come again and some justice is provided. :o But realistically, camera...
  4. E

    Help - robbed during lockdown

    Unfortunately we were in Level 4 Lockdown so there was nobody on site for the whole time. Also the roller door isnt in the footage as its directly lake facing, so we have very little ability to mount a camera, unless we attach it to a duck. Certainly does... and they are coming to give it a...
  5. E

    Help - robbed during lockdown

    I believe it does, but we moved from the cams from being on the network and config'd for motion detection to go directly into the NVR when we upgraded. Seems in that process they got set to permanent record. Any ideas on ripping through these videos...
  6. E

    Help - robbed during lockdown

    Bloody good call... doing it now. Thanks - you just narrowed the amount of footage to review to only 4 weeks now... :( But appreciate the comment.
  7. E

    Help - robbed during lockdown

    Hey Guys, I really hope you can help me! I am part of a boating club and we were robbed during the last 5 weeks of lockdown. They were good as they managed to breach an alarmed boatshed without triggering the alarm system open a roller door and steal a number of outboards. We have cameras...
  8. E

    Remove mounting from hfw5431ep-z

    Hey Guys, we have the above camera and we need to remove the mounting arm right back to the camera as it is going into a custom mount. Any idea how I go about doing that? When I tried to disassemble the mount I found the black plastic block on the cables was too big to pass back through the...
  9. E

    Analogue from IP Camera Stream

    The HDMI splitter approach is certainly one we are considering, but we are not keen on using the HDMI to RCA adapters. We already gone through two that have bricked themselves. The Pi idea could be interesting - thanks. If we got them set up right (and it certainly would be a learning curve!)...
  10. E

    Analogue from IP Camera Stream

    I am not sure what video signal splitters are? As for graphics cards, yes we could add more, but we are running into a few limitations. Here is what we would need to do with the decoding PC: 1x HDMI signal showing either 1 or 3 cameras depending on the event we are monitoring. - The same...
  11. E

    Analogue from IP Camera Stream

    Hey Guys, thanks for the help you have offered so far with our setup. We are having one major problem though that we cannot get resolved and any advice is appreciated... basically we need to decode 4 camera streams to an analogue BNC / RCA composite feed. Long story short, these will feed...
  12. E

    H Andy, I need 3 cameras and not sure which models to choose. All must be HD and 25fps+ as they...

    H Andy, I need 3 cameras and not sure which models to choose. All must be HD and 25fps+ as they will be monitoring a sporting event (day only). No1 (x2) needs big zoom (90mm min) box/bullet form. It will be mounted in a box. No2 needs to be above HD, 2-3mm to 13.5mm and IP67 bullet and ideally...
  13. E

    Camera Dilemma - odd situation

    Oh, and if relevant, these will all be going through a ubiquiti network and running on battery, so passive POE is appreciated but not essential.
  14. E

    Camera Dilemma - odd situation

    Hey Guys, got an odd situation for you. We are looking for cameras for monitoring a sporting event, so the requirements are a little odd and would appreciate some advice/help. Basically we need 4x cameras for the first phase, but possibly a number more. Based on testing so far, we think we...
  15. E

    Getting 3x analogue outputs from IP Cameras?

    Hey Guys, Newbie here to the IP Camera world - but got a fair bit of networking background. I am helping a sports club out with a wireless system they will use for judging events and they have a couple of odd requirements I need your advice on... so for background - the system I am planning...
Top