Recent content by jpapanas22

I’m using the powerline adapters that come with the Logitech alert system. I’m using the following - see attached

This is very interesting - we have a 6 camera Logitech Alert camera system that we have been using for years as well. About a couple of weeks ago, we also had all cameras start losing connection, reconnecting for a bit, and losing connection again, over and over. This continued over a period...

I had a similar question recently... see this thread - it may help: How do you access all cameras on an NVR in BlueIris? In summary, get the IP address of your NVR, use that in the address field when adding a camera on the ‘Network IP camera configuration’ page and change the ‘Camera’ number...

With respect to the waterproof cover, I recently tried this on a Reolink camera/NVR kit - the waterproof cover also fit over the pre-made rj-45 connector on the cables supplied in the kit. The cable ends look very similar to the yellow cable end you have in your pictures. However, when you...

Yes! That did it - thanks fenderman and TL1096r!

Ok, I added another camera using the same ip address - but this time changed the camera number to 2 - however, i still get the stream from the camera on channel 1. I've reset the cameras, reset the nvr, deleted all cameras from Blue Iris and started again - still can't get the stream from the...

I'm using Blue Iris 5 in Demo mode to try it out. I'm trying to access all the cameras on a Reolink NVR RLN8-410. There are two Reolink RLC-410 5MP cameras attached to it, but I can only access the one on Channel 1. I used the ip address of the NVR - 192.168.1.20 along with it's username and...