How do you access all cameras on an NVR in BlueIris?

[jpapanas22]

I'm using Blue Iris 5 in Demo mode to try it out. I'm trying to access all the cameras on a Reolink NVR RLN8-410. There are two Reolink RLC-410 5MP cameras attached to it, but I can only access the one on Channel 1.

I used the ip address of the NVR - 192.168.1.20 along with it's username and password and was able to access the camera on Channel 1 - see configuration settings below. How do I access the other camera on Channel 2?

 

[fenderman]

I'm using Blue Iris 5 in Demo mode to try it out. I'm trying to access all the cameras on a Reolink NVR RLN8-410. There are two Reolink RLC-410 5MP cameras attached to it, but I can only access the one on Channel 1.

I used the ip address of the NVR - 192.168.1.20 along with it's username and password and was able to access the camera on Channel 1 - see configuration settings below. How do I access the other camera on Channel 2?View attachment 44410

change the camera number to 2

 

[TL1096r]

@jpapanas22 let us know how the reolink works with BI. You must do some trickery to get it to look good without lag on BI.

 

[jpapanas22]

change the camera number to 2

Ok, I added another camera using the same ip address - but this time changed the camera number to 2 - however, i still get the stream from the camera on channel 1. I've reset the cameras, reset the nvr, deleted all cameras from Blue Iris and started again - still can't get the stream from the camera on channel 2 to show up. All cameras i add from this NVR, seem to be the same camera on channel 1.

 

[fenderman]

in the path that you have in the first clip try changing 01 to 02

 

[TL1096r]

Try:
/h264Preview_01_main
and
/h264Preview_02_main

 

[jpapanas22]

Yes! That did it - thanks fenderman and TL1096r!