Well, as near as I can tell, it must be a bad connection. Bringing the camera inside and connecting it directly to the switch allowed me to reconfigure the camera. What's odd is that my cable tester says the line is good to go. Going to redo the RJ45 connection on the camera end to see if that...
I agree. But I would expect at least SOME traffic/blinky lights on my switch...discovery/ping or otherwise. My default network is 192.168.0.0/24 and even when I configure my laptop to use 192.168.1.0/16 ConfigTool still isn't able to discover the camera.
Thank you for the replies. I've managed to get a couple of my other cameras set up the way you've described but these two cameras just don't seem to even show up.
I have disconnected one, and power cycled the port of the other, however, the one is still showing up as powered but disconnected...
I am currently trying to install two IPC-HRW5421E-Z12E (Loryta POE Turret 2MP) and I'm running in to an issue.
When I connect both cameras, Unifi is showing that there is power draw via PoE+ but it's showing a disconnected state (top right and bottom left):
I verified the cabling using a...
Hello all,
I'm starting the build out/install my POE security system with BlueIris. I have attached my current thoughts on how I am planning on approaching the installation.
KEY:
Stars - Entry points (doors/windows)
Yellow - Identification as these are access points in to the house...
I am looking for POE, ceiling-mounted, indoor-use cameras that are inconspicuous or non-intrusive to the eye. Looking to place them in the kid's rooms and in common living spaces. Primarily used to monitor small children as well as replace our current baby monitor (so would prefer sound)...