Recent content by samys

They are not upside down, and checked again, it didn't happen when i was unplugging them it just happened at 4PM one recording is normal and the next one is upside down and mirrored :(

Hi everybody, just a quick question, any idea why after i disconnect the cameras from the switch and connect them again (or maybe i restart the NVR - Synology NAS) the image is flipped and mirrored, this is not happening with a third camera IPC-HDW5231R-ZE. Thank you.

Hi, I have 2 x IPC-HDW5231R-Z and a IPC-HDW5231R-ZE (might get more in the near future). I am moving from a router to a mesh and I need a switch with more ports, so I was thinking going for a Netgear POE switch. I have two options on Amazon, a 16/183W or a 16/76W. Which one to go for, can I use...

I have had just about enough using the Synology Nas as an NVR, one day working, the next not working, fixed one day, update the software, nothing works at all. Can you please recommend a good NVR, I have 2 5231's, might get a ZE soon. I have a NETGEAR GS308P 4 port Poe out of 8. Thank you.

Tried to change DNS but camera software wouldn't save the new one.

Hi, I try to block my IP cameras Ip (192.168.1.***) but I can't access them from outside my local network, I have a pia account, someone mentioned open DNS, any steps to follow, I have a Netgear nighthawk r7000 router.

Any idea what setrings can I change for this to get a bit brighter, I should move the center up and to the right too.

How to access this camera from the internet? I have an android phone, using gDMSS Lite, but working only on the local network as I added the local IP. What setup do you have? Thx

Latest device pack. Here is what i get (don't mind the "B" in the selected camera, i sorted that, chose the right camera). Any Ideas ? RTSP tried Auto TCP UDP no difference.

I just got the camera, and the firmware it came with is v2.460.0000.14.R build 20.07.2017, this one is higher than what there is on the official website. Where could i get the device pack please? I select at the firmware section in the SS higher than 10 and shows disconnected, even if the test...

Hi, do you run it on an nvr? If so what type an model please. Thx

Here is the junction box:

Silly question, how do you acces the cameras then. I am using a Synology NAS, but having trouble to set up the 5231:(. Thx

I just bought this junction box, will upload a few photos when I get home if you want.

Hi, how do you block the cameras from accessing the internet, thx. What is the switch model please.