Recent content by Tibbar

Hi. I'm using exact camera with Dahua ePOE switch with full spool of 1000ft cable. Works like a charm.

Oh ok. My bad.

I've never run it on tour. The cam would be moved on average few times a day.

Yes i'm positive.Almost all my devices are on static IP and ones that are on DHCP are managed by pfsense Before the camera went dead it was on separate network. All my cameras are on 192.168.50.x. after resting the camera it shows up briefly as 192.168.1.108. Even if I connect the camera...

Location?

The camera after boot up briefly shows up on IP scanner with 192.168.1.108 but still can not access it and then connection is dead.

No they are fine. Camera boots fine with PoE. Last result would be to remove a Ethernet cable from other camera and try it.

I dont think you know how watts and amps correlate.

Lets just forget the power requirements. I tried with PC power supply that can deliver 12A, same results.

So you questioned me using 30W adaptor.

:lmao: No I did not ask how huge is your power adaptor. I asked how much PoE+ (802.3at) spec is.

And how much power does PoE+ (802.3at) provide ?

No not really related. I can not see the camera on network .

Yes. Have you used SD49225T before ?

Yes I did all that ( like I said the laptop is set with static IP address of 192.168.1.x), still nothing.