Recent content by tom.k

I am trying to set up recording for a single camera using nvms7000 Camera is setup and works in live view I have set up a separate 500mb partition on a network computer I can see the separate hdd in Storage Server/Remote Config/Storage/General and the globe is green at the main Storage Server...

I have LTS / HIKvision cameras Have been able to configure and test emails. Confirm gmail accounts send and receive test emails have used the following settings to configure motion detection I go out into the yard and jump up and down to set off camera motion detection alarms are sent to...

went back in and deleted single port forwarding updated address to external ip address and ports for each camera all cameras show up in live view under cell that is not on wifi Thanks for all your help - greatly appreciated next step will be to confirm this works on computer off network -...

i don't know what happened, but live view is showing up under the external ip address

when i enable DHCP, the camera wants to reboot, but changes the ip address and locks up is this what you mean by 'reserve the dhcp address'

thanks code i had enable ddns, disconnecting did not make a difference server ports look like they are set up correctly should ipv4 address be similar to external ip address, or should it be address on network setup?

upnp was not disabled disabled and reboot router no change - still get connection failed message

rebooted router and switch - still connection failed message did not see port forwarding on zyxel switch

good work code2

set up for internet connections and switches 1 - cable from curb into modem 2 - modem out to linksys ea4500 3 - linksys ea4500 connects to zyzel 8 port POE switch 4 - zyzel 8 port POE switch connects to cameras

went to canyouseeme ip address is consistent with address i have been using updated port from 80 to 8000 and hit test button response - error could not see service on port 8000 reason connection timed out

changed port from 8150 to 8000 in camera software, rebooted device, and saved set up single port forwarding in router to 8000 for internal and external changed port on nvms7000 software on cell received connection failed message

when i go to browser and enter canyouseeme.org i get a response of same external ip address with port 80

from camera software from router - - - Updated - - - sorry, does not like how i am picking up screen shots