Recent content by tony22

I don't mind running Cat cable through my attic. Already did that for my internal hard wired network. I can use the existing coax as a feeder to "pull" the Cat out to the through points around the outside of the house. Yes, I was thinking I'd add another camera at that #5 location. I'd just pull...

Now that the inside renovations on my house are finally done, I can address the replacement of the existing outdoor security cams around my house. I attached a pic showing my lot and the house, with the location and number of each existing camera (pointing angles are only approximate). These are...

I had to both unplug it and remove the battery. When I put the battery back in I was able to disarm it. The system has been installed and in use since March of 2019. Interesting. Unfortunately my router logs don’t go back far enough to see if such a thing happened at the time the base station...

Mine has been plugged in since I installed it. What you described is the way I had been using it - similarly with no issues - up until this last occurrence, where it was Armed 24/7 for over a month. It was during this utilization when it locked up and showed Offline.

@fenderman, what’s the longest continuous period of time you’ve run either of these?

I’ve had it since last year. Up until now it’s been used for at most maybe a week / 10 days at a time - the vast majority of times much less. What bothers me is there appears to be no “failsafe” reboot behavior or something like that in the base station, so that it would have a way to detect...

I was away from home for a while, so I activated my Ethernet hard-lined Ring Gen 1 alarm system (consisting of contact sensors, motion detectors, and fire/smoke sensors). While away I’d check it every so often to make sure all was good. About a month after I left I checked a Ring pop up to...

Well, that was relatively easy. I have one Zone not working but I think that’s because I may have mislabeled the Common for that zone. That circuit doesn’t open up when a contact is opened. I’ll hunt it down tomorrow. I even got the motion sensors working by letting the old Magnum system supply...

No, I have not. Thank you!

My new (to me) house has an old Magnum Alert 1000e hardwired installation. Since Ring recently came out with this Retrofit device, and my Magnum system is set up with a number of zones that will work with the Retro, I decided to get it. Should have it tomorrow. In the meantime I’ve set up a...

Anybody out there able to help?

I moved into a house that has an old security cam setup - 8 analog cameras, and a DVR hidden away in the house. I had to dig up an old VGA monitor to attach to the DVR so I could take a look at what was still working. I am attaching front and back view of the DVR, and one of the remote, in case...

This is about as timely as it gets. I just bought a house that is outfitted with an LTS LTD 2408 DVR and a full assortment of fixed and PTZ coax cams. I was not looking forward to crawling through the attic to replace the coax with Ethernet, but at the same time I wasn’t sure if the LTD 2408 was...

The keypad is at the top of the stairs just inside my bedroom and the repeater is at the bottom of the stairs. Standard length staircase. It'd been working fine since the day of installation up until about three days ago.

Nice! Any nighttime views?