Search results

Linux isn't supported

I have wifi running on difference channel than all my neighbours and i'm not in a densely populated street, only 6 other APs around. It runs great on the camera with 99 strength obviously, but the 55 one keeps losing connection, but 55 isn't really that bad, is it?

Sorry for the multiple threads but these are all separate issues. I'm trying to turn off display name and timestamps on my cubes because zoneminder handles this for me. However, when i click save it just says "parameter error", but i'm not changing anything apart from unticking a checkbox. In...

So, i have 4 dome cameras that are all PoE, never had a single drop out that i remember of course why would i? Just hooked up a few via WiFi (cubes), one has signal strength according to the UI of 99, and the other 55. The one at 55 is unusable, UI keeps failing, and the stream to zoneminder...

Yea i guess it does give the ability to remove, but that would also be possible with a UI checkbox and a lot less hassle! :D

Yea i did that before reading your post and it seems to be doing the job, light still getting out from the sides of the tape so will need to wait until tonight to see for sure but will be far better. It's a shame they don't have the ability to control these in the firmware, lots of hardware...

Tried it, doesn't work

It'll still glow, i want them off!

So, after someone mentioned to unplug the LEDs i dismantled my camera a little to take a look, and the LEDs are obviously on the board as i thought. Could i literally pull them off with pliers without causing some in the firmware because no current is able to pass through them?

All 3 on my cube I would like off, status, alarm, link I think they are called. I would have preferred to do it via the firmware before opening up the unit, and I didn't think they would be "plugged" either. I will open it up if you think it's a non starter to do it via code. Also about the...

@alastairstevenson Thanks, tried it and no change though for me. Port 22 is still filtered :( @montecrypto To save me some time, is it possible to get these LEDs turned off or is that going to be deep in the drivers? I can donate a little bitcoin if that sways you PM me :)

@alastairstevenson I added "/sbin/iptables -F" to the end of the initrun.sh with no joy. Did I do it correct as you suggested or miss something? PORT STATE SERVICE 22/tcp filtered ssh

Welcome to 2017, @montecrypto 's bitcoin address is in the binary help text :D

@alastairstevenson Thanks for pointing me here. I have a DS-2CD2442FWD-IW camera and would like to try and enable SSH. Having read your post a few up on this page i see i can unpack 5.4, edit and repack. Though i saw on the first page something about camera specific keys, am i out of luck with...

Thanks, will take a look now!

I'm looking to see if its possible to turn off LEDs on my cubes. Any chance you can upload the source for this, any chance i can build it as a linux binary ?

ergh, not a solution! I see some people around here are modifying firmware etc, could that be a potential route? I'm happy poking around so maybe i'll take a look if someone can point me in the right direction

Hi, I have recently purchased some cubes and there are 2 bright blue LEDs and a flashing amber one for networking on the front. Is it possible to turn these off? I've looked through all settings and can't find an option for it. Thanks!