Search results

I got the software working with with my HikVision NVR on Cloud P2P. I can see all the cameras and intrusion/line crossing detection layouts on the main feed. But when I go to the remote configuration for any of the cameras, all I can see are the detection settings (sensitivity, etc) for the...

i fixed it. Just unchecked the Hik-Connect box on the NVR, hit Apply, then re-checked it and changed the verification code, then hit Apply. Whew.

Hey All, I downloaded the new IVMS-4200 software for the Mac and tried to add my NVR to it via the new P2P connection option which I assume is the same as Hik-Connect. I entered the serial # as required and the verification code to the one I set when I set up the NVR. No luck though it did see...

Well that's strange...now it's working for no apparent reason <shrug>.

Excuse me, I meant push notifications from the NVR to my Phone. I get them from 2 of the cameras I initially installed, but not the 3rd one I just installed recently.

Hi all, I just added another HikVision camera to my current set so I now have three of them. All are connected to HikVision NVR. I set the new camera notifications identical to the other two, yet I do not get any notifications from this particular camera. It is the same model as the other two...

Yikes that's an expensive camera! Don't have any advice but if you bought it from a Hikvision distributor they should be able to help you.

Ok. Mine is DS-7608NI-E2/8P. It has the latest firmware/software.

Thanks. I think I understand what I did wrong and it's working the way I want now. I haven't decided yet whether to just increase post-recording time or set continuous recording and look for events on the timeline when I get a notification. Other than that I'm pretty happy with what I've done so...

Yes I missed a couple of things. My NVR GUI looks different than what you have posted but I get the gist of it.

Well it turned out that I thought I had Notify Surveillance Center checked on the settings for the intrusion and line crossing, but I didn't :facepalm: I was expecting a notification to alert me that things were working properly since I don't have continuous recording set (yet). Too bad these...

Well I set the recordings to Event but intrusion detection and line crossing, though enabled, apparently will not work without motion detection turned on even if the sensitivity is all the way up and percentage is at 1. This is counterintuitive if you only want intrusion and line crossing...

That may be the problem. I'm not able to get to my NVR right now, but I'm pretty sure I have the storage mode set as "Motion", so that may be the issue. I'll check it later today.

Hi All, Glad I found this forum. Lots of useful information. I bought some Hikvision IP cameras and a Hikvision NVR. Everything is hooked up and working. I've been piddling with the intrusion and line crossing settings but they don't seem to work even though they are enabled on the NVR. I...