Search results

Try using this Legrand Wiremold Non-Metallic PVC Raceway 5 ft. Wire Channel, White NMW1 - The Home Depot to move the camera and wire to a new location. Finish paint after installation.

The IRs will go off during rebooting and then should come back on when the unit finally resets itself until the next boot loop.

I want to shout out to Chris for looking into a possible upgrade into these cameras. The firmware versions seem to be older than what my cameras list. Has anyone tried to upgrade the firmware for any of these cameras to an older firmware version? I am thinking about trying this but just...

Cameras may have had access to the internet. Not real sure since they are networked. None of the cameras have had any firmware updated. Problem cameras are IPC-HDW4433C-A and IPC-HFW4431R-Z. I can connect to each camera via Internet Explorer within the network. I deleted the camera from...

Well.....wanted to give everyone an update on the rebooting Dahua IP cameras. The cameras that are rebooting, were found to be the Chinese clone cameras aka "OEM" Dahua IP cameras. These cameras do not permit themselves to have their firmware updated. So basically, they are nothing but bricks...

Thanks. Firmware updates are current on both routers. There are no NVR and Camera updates. Checked all of that. I will work on the problem cameras first and isolate them from the POE switch with their own power supply. I just ordered a new network cable tester that can check POE lines. I...

Hello. Thank you for your reply. Here is my response to your questions. 1. I would isolate one cam at a time and let it run outsideof your network, like just watching it on a PC with a spare poe switch or power injector. See if it still has the same issue isolated, - I can do this. I have a...

Hello. I have a combination of the above cameras that are tied into a Dahua NVR4216 (16Channel). Total of 12 cameras. Within the past few weeks, the 4 out of 12 cameras started rebooting at random times. As much as a 12 to 24 times in an hour. All are connected to several POE switches. I...

Hello Kevin, The only reason we are looking at WiFi Cameras, is that (1) reasonable cost, (2) lots of available "free" wifi connections from local homeowners all depending on where the cameras are set, and (3) available local power. Steve

Hello Group. I am still a newbie when it comes to IP Cameras. My questions is, for our Neighborhood Watch in our small community, we would like to setup Wireless IP Cameras at various locations. Each location has Wifi capabilities available from various homeowners. Cameras we want to test...

Yes I did resolve the problem. First, the Cat5/6 wiring must be a certain way. There is a specific wiring diagram to follow. The chart that Fenderman recommended previosly in this post was the trick...

I will do that today and repost with results. Thank you!

My wiring is very similar to the chart link that you provided. Pin 1 2 3 4 5 6 7 8 B Chart o O g B b G br BR Mine o O g G br BR b B I purchased a iSmart POE power kit. Model ISM-POE104F. Function Description: POE...

UPDATE Hello Everyone! I purchased a POE Injector / Splitter, 4 Port, 48 volt, 65 watts. The "splitter" draws down the power at the camera end to 12 volts 1-2 amps. Which is in line of what the camera specs are. I connected everything up and plugged into the camera with the 120' Cat 6 run...

Thanks for the reply. I will certainly look into that. Will 48volt POE harm my camera?

Hello, I have been piece mealing my IP camera system together for several months. This is now turned out to be a hobby. Not that I really need one. The longest run of Cat 6 cable from the network switch & passive POE power source in my garage to a camera is about 120'. All other cameras are...