Search results

Hi thank you very much for your response , but this camera dont have microsd card slot and reset button, it is a dome type of camera.Probably I should look for contact with the manufacture in case they have some key gen code probably.

Hi , does anyone knows how I can eventually reset Balter ip camera?!?The model is: IP-DR2441VR. It has open ports :80, 554, 8080, 9999 and 55666.Password is unknown , unfortunatlly I cant use it.

Hi, does anyone knows is it possible this kind of ip camera to be reset? I have used Sadp tool, camera ip is 192.168.254.6/SM 255.255.255.0 / GW 192.168.1.1 which is not in the same network as the camera. I have sent the export file annke and their support was very fast but the file they have...

Hi, does anyone know is it possible for 2wire 1 button outdoor station to ring simultaneously to 2 monitors? I have installed 2 of them to my cousin yesturday but it is always connect to one of them. Via hik connect app he is connect to both of them so he is notified when anyone contact with...

Hi CC, thank you very much for the advices and the guides, till now I have tried several times to reset it.Short time /10s/ and long time /35s/ press of the reset button without any result.The only positive result after last firmware is that now the camera is visible by the latest config tool...

Hi, I am newbie and I find this forum very useful however do you know from where I can download firmware for this dahua camera -> ipc-hdbw5300P?I think I brick it, however ports 23, 3800, 42323 are open, ping to 192.168.1.108 is valid...but it restart on every minute.I have download older...

Hi, well the nvr is working but it has only admin account and for forgotten password it will send file to an email that neither I or the seller has access, the same situation is with the secret questions. I see the nvr via vga and with config tool too, but I cant reset it and also I cant...

Hi, I have bought this nvr on auction 2 weeks ago but the seller doesnt know the password and he doesn't have an access to the recovery email too. Now this nvr is totally useless and I dont know what to with it.Is there any way to be reset to factory default settings?

Super now it is start to work in motion detection mode,I think it is important when you make and finish settings to go in >Adv. Conf.>System>Maintena1nce>reboot, after that leave it towrk 5 minutes min. , before to check on playback. Sent from my LG-D855 using Tapatalk

Mine start to work afer I have made on continuous mode to record.Two days ago I have read /in cctv forum I think but I am not sure/ that these china cams after upgrade to 5.3.0 go in chinese menu, so solution is to change a 2 or 3 bytes of file before to flash the firmware. Sent from my...

Well I have made a reboot and actually it has been recorded till now probably I didn't see immediately when it made record because files are too large,however the problem with motion detection stays. Sent from my LG-D855 using Tapatalk

Hi I have the same problem with hikvision camera bought from ali and one 32gb sd card . Sent from my LG-D855 using Tapatalk