fail
-
ESCAM Brick QD300 dead.
Hello Again. My eScam brick has become that, a brick. It won't echo back nor connect. It turns on and the network dongle lights up like it should, the IR goes on and off. Just no LAN connection. Any suggestions? I find that the network i/f is by FAR the most common failure in cameras. I've...- Matt L.
- Thread
- escam fail
- Replies: 6
- Forum: IP Cameras
-
C
Terrible picture of thief SD59225U-HNI
My Dahua caught a thief but the picture quality is terrible :( the motion tracking didn't do it's thing either. The motion tracking is moody at best, I find that I have to move the camera around a bit every now and then to make sure the motion tracking is doing it's thing. What am I doing wrong?- cornholio
- Thread
- bad picture fail motion tracking sd59225u-hni
- Replies: 32
- Forum: IP Cameras
-
E
Hikvision FW update fail. How to fix ?
Dear all, I upgrade hikvision camera model : DS-2DF7274-AEL. After I uploading file via browser finish It's fail and I can't fine IP address any more. I try to use TFTP to upgrade my camera. The camera didn't reboot after upgrade. I can ping and access the camera via telnet, but no access via... -
G
DS-2CD2132F-I recording to NAS - Recording Fails
I have three DS-2CD2132F-I all on firmware 5.3.0 build 150814. These all record (events only, not continuous) to separate SMB shares on a NAS with quotas set. The shares are 800GB and 2 x 515GB, recording is set to overwrite. All is well until for some reason the recordings on one or more... -
O
no access after firmware upgrade (DS-2CD2132F-IWS to 5.3.0 build 20150814)
:sad:Hi, I have a DS-2CD2132F-IWS connected by LAN wirh POE. Address is 192.168.2.46 with port set to 8113 - this was before the "upgrade" I downloaded...