I've run a number of site searches through Google but most of the results I found weren't exactly what I was thinking. So, I'm hoping you guys might be able to point me in the correct direction.
I have three (3) exterior mounted POE cameras that I'm looking to install soon (already have the...
Ive had my system installed for around 1 year and have replaced the Longspan extenders twice and the gate controller twice. Im not sure what else I need to do. These were not direct hits either.
The system starts coming off the hub to a Longspan into Ubiquity ETH-SP-G2 and then exits the...
Hey guys!
Lightning struck my place and I did not have my components in a surge protector at the moment it happened which was also by chance because normally it is protected. The timing sucks but initially it looked as if the only component that fried was the modem. The other parts being the...
Hey guys, installing 4 new cams onto the top of a rather tall wooden post 25-30 feet. It already has a lightning rod on the pole with a good ground. Would something like this be sufficient to protect my system if I install it on the inside of my house? Currently don't have any dedicated surge...
I was wondering if anyone knows about POE Cameras and ground them when they are outside? I am being told that since they are over a cat5e Ethernet I should have an inline surge suppressor on the line. Quick information on my what my setup will be:
(House) 2 outdoor POE Cameras mounted on brick...
After ton of reading and research for the past week, I am getting closer to a plan for my install. Orders have been placed and I need some guidance to see if there are any issue with this plan (Network Diagram)
Anything in RED on the diagram I am not sure about the placement and /or issues I...