Block parts of it out in the zone. This will prevent that area from being analyized.I have a flag right on my front porch and I was getting false positives on a person. It's my flag, I tried raising the confidence level to 60% and still no luck..
Any ideas?
Sent from my SM-G781U using Tapatalk
The problem with that is the area is not recorded during a motion event. If you just remove the are in the BI zone it will still record that portion.I had a similar problem with two mailboxes. Went into the camera and set a privacy zone over each of them. Problem solved.
Agreed. Might have to move the flag elsewhere.The only alternatives I can think of would be to move the flag or move the camera. That sounds too close for a privacy zone in the camera without compromising detection in BI.
Thats fine. As long as your remove only parts of the flag, it wont analyze those areas and thus wont return a person. It will still trigger when a person walks by.I'll have to mess around with it on BI tonight. My only hesitation is that anyone walking up to my door has to talk past that flag
Sent from my SM-G781U using Tapatalk