Are people typically using the round PVC conduit junctions to mount turrets or...

[rufunky]

Are people typically using the round PVC conduit junctions to mount turrets to PVC conduit runs or the metal ones that you buy specifically for the cameras?

I'm not even sure if the round, conduit, PVC junction boxs are compatible with dahua turret mounting holes?

 

[crw030]

I try to buy the matching boxes for each camera I order from @EMPIRETECANDY because they aren't terribly expensive and are well constructed and pretty well sealed to prevent moisture intrusion.

 

[rufunky]

I try to buy the matching boxes for each camera I order from @EMPIRETECANDY because they aren't terribly expensive and are well constructed and pretty well sealed to prevent moisture intrusion.

Ok, thats what I planned on doing. I have the matching junction boxes but I can not figure out what adapters I need to connect the 3/4 PVC conduit to the metal dahua junctions.

What do you use?

 

[ljw2k]

If you are in the UK kenable do junction boxes encam CCTV Cameras and Recorders

 

[rufunky]

If you are in the UK kenable do junction boxes encam CCTV Cameras and Recorders

Thanks, I'm in the US.

I already have the junction boxes, just not sure what adapters I need to connect them to the 3/4 pvc conduit.

 

[BigFoot]

I use IP6X project boxes, with the camera mounted onto the front panel with short brass fixings

 

[dudemaar]

Ok, thats what I planned on doing. I have the matching junction boxes but I can not figure out what adapters I need to connect the 3/4 PVC conduit to the metal dahua junctions.

What do you use?

Take the Dahua junction box to a electrical supply store and show them your issue. I’m sure they can help.

 

[Riclyo]

Thanks, I'm in the US.

I already have the junction boxes, just not sure what adapters I need to connect them to the 3/4 pvc conduit.

are you thinking of a 3/4” pvc TA fitting?

 

[rufunky]

are you thinking of a 3/4” pvc TA fitting?

Yes, but I need it to be 3/4" female to 1/2" male I believe. ( think the dahua junctions are 1/2" inlets.

 

[crw030]

think the dahua junctions are 1/2" inlets.

Might depend on the box, I have one here for Dahua IPC-B5442E-Z4E and it definitely appears to be 3/4" threads. Smaller ones might have one or both 1/2" & 3/4". I suspect these are pipe threads that are very common if you visit a Home Depot or Lowe's with Dahua box in hand.

 

[Riclyo]

If you do have 3/4” pipe but a 1/2” threaded inlet you’ll only find that in plumbing afaik

 

[rufunky]

So I made a trip to home Depot with the junction box in hand. This is what I came up with in case someone else runs into this issue.

I think the 3/4 inch box adapter it's supposed to slide through from the inside but this seems like it should work.

 

[rufunky]

Well, I got the conduit run. It should be quite a a chore snaking the cable through